TM 1-2840-252-23-2
5-22
INSTALL STARTER DRIVE ASSEMBLY (Continued)
5-22
NOTE
In following step 1, gearshaft may have to
be rotated slightly to engage splines
1. Install gearshaft (1) into widest portion of hole (2).
Guide straight in until splines (3) engage with internal
accessory drive gear splines
2. Install packings (4 and 5) on starter gearbox assembly
(6)
3. Install packing (7) in housing assembly (8)
NOTE
In following step 4, splines may have to be
rotated slightly to engage properly
4. Engage spines (9) with splines (10). Install starter
drive assembly (6),four washers (11), and nuts (12)
GO TO NEXT PAGE
5-71
