TM 1-2840-252-23-2
4-17
INITIAL SETUP
Left- and Right-Hand Bus Bar Assemblies Re-
moved (Task 4-7)
Fireshield Assembly Removed (Task 4-12)
Applicable Configurations:
All
Left- and Right-Hand Fuel Manifold Assemblies
Removed (Task 6-15)
Tools:
Powerplant Mechanic's Tool Kit,
Fireshield Section Removed (Task 4-16)
NSN 5180-00-323-4944
General Safety Instructions:
Goggles
WARNING
Compressed Air Source
Materials:
Dry cleaning solvent (E19) is flammable
Dry Cleaning Solvent (E19)
and toxic. It can irritate skin and cause
Gloves (E24)
burns Use only in well-ventilated area,
Personnel Required:
away from heat and open flame In case
Aircraft Powerplant Repairer
of contact, immediately flush skin or
Equipment Condition:
eyes with water for at least 5 minutes
1
.
Off Engine Task
Get medical attention for eyes.
Tube Assembly (No 4 and 5 Bearing Scavenge
Connector to Tube Assembly) Removed (Task
8-71)
1. Wear gloves (E24) Clean fireshield section (1), using
dry cleaning solvent (E19) and brush.
WARNING
When using compressed air for cleaning,
use approved protective equipment for
eyes and face. Do not use more than 30
psig air pressure. Do not direct air
toward yourself or another person.
Failure to comply could result in injury
to eyes or skin. In case of injury, get
medical attention.
2. Wear goggles Blow dry fireshield section (1), using
clean, dry, compressed air.
FOLLOW-ON MAINTENANCE
Inspect Fireshield Section (Task 4-18)
END OF TASK
