TM 1-2840-252-23-2
2-47 REPAIR INLET HOUSING COVER ASSEMBLY (AVIM)
2-47
INITIAL SETUP
General Safety Instructions-
WARNING
Applicable Configurations:
All
The inlet housing cover is made from a
Tools.
magnesium/nickel alloy containing ra-
Technical Inspection Tool Kit,
dioactive thorium; particles of this ma-
NSN 5180-00-323-5114
terial, resulting from blending or polish-
Materials-
ing are hazardous to your health if in-
Carborundum Stone (E10)
gested or otherwise introduced into
Crocus Cloth (E15)
your body. Do not eat, drink, or smoke
Gray Enamel (E26)
In any area where these particles might
Personnel Required
:
be present. Wash your hands thoroughly
Aircraft Powerplant Repairer
after working with this material If expo-
Aircraft Powerplant Inspector
sure or injury occurs, no matter how
References:
Task 1-110
slight, get medical attention.
Equipment Condition:
Off Engine Task
WARNING
The Inlet housing cover Is made from a
magnesium/nickel alloy containing ra-
dioactive thorium; particles of this ma-
terial, resulting from ble ding or polish-
n
Ing are hazardous to your health if In-
gested or otherwise introduced Into
your body. Do not eat, drink, or smoke
in any area where these particles might
be present. Wash your hands thoroughly
after working with this material If expo-
sure or injury occurs, no matter how
slight, get medical attention.
1. Repair nicks and scratches less than .030
0
inch deep on inlet housing cover assembly (1) as
follows
a. Blend all sharp edgesnext to nicks and
scratches Use carborundum stone (El0)
b. Polish to smooth finishUse crocus cloth
(E15)
2. Repair damaged paint or corrosion n inlet
o
housing cover assembly (1) Use gray enamel
(E26) (Ref Task 1-110)
INSPECT
FOLLOW-ON MAINTENANCE
None
END OF TASK
