CLEAN AND INSPECT PURGE VALVE ASSEMBLY

CLEAN AND INSPECT PURGE VALVE ASSEMBLY (Continued)

TM-55-2835-208-23 Transportability Guidance Small Emplacement Excavator (SEE) High Mobility Entrencher (HME) High Mobility Material Handler (HMMH) Manual
Page Navigation
99

TM 55-2835-208-23 2-29 CLEAN AND INSPECT PURGE VALVE ASSEMBLY 2-29 INITIAL SETUP Materials: Applicable Configurations: Methyl-Ethyl Ketone (MEK) (E9) Lint-Free Cloth (E13) APU 116305-100 Tools: Personnel Required: Rubber Gloves 68B Airrcraft Powerplant Repairer NSN 8415-00-266-8677 68B Powerplant Inspector Container Eye Protection Equipment Condition: Off APU Task MEK (E9) is flammable and toxic. It can irritate skin and cause burns. Use only in well-ventilated area, away from heat and open flame. Wear gloves and eye protection. In case of contact, immediately flush skin or eyes with water for at least 15 minutes. Get medical attention for eyes. 1. Soak purge valve assembly in MEK (E9) for 5 minutes. 2. Remove from MEK and dry with clean lint-free cloth (E13). 3. Inspect thread fittings (1) for crossed or stripped threads. If damaged, discard. 4. Inspect purge valve body (2) for cracks or gouges. If dam- aged, discard. GO TO NEXT PAGE 2-58

Privacy Statement
Press Release
Contact