TM 55-2840-254-23
9-14
INSTALL TORQUEMETER HEAD ASSEMBLY (Continued)
9-14
NOTE
The output shaft, torquemeter head assembly, and
torquemeter junction box are supplied as a
calibrated, matched set.
If you replace the
torquemeter head assembly, you must also replace
the output shaft (Tasks 9-6 and 9-10) and the
torquemeter junction box (Tasks 9-1 and 9-5).
NOTE
If same torquemeter head assembly and shim that
were removed are being installed, omit steps 1. and
2. If replacement torquemeter head assembly or
shim is being installed, do all steps.
1.
Determine what size shim you will need as
follows:
a.
Measure from flange (1) to bearing outer
race (2). Result is Dimension A (3).
b.
Record Dimension A (3).
INSPECT
GO TO NEXT PAGE
9-50 Change 6
