TM 55-2840-254-23
8-18
8-18 CLEAN OIL FILLER ASSEMBLY AND OIL FILLER STRAINER
INITIAL SETUP
General Safety Instructions:
Applicable Configurations:
All
Tools:
Powerplant Mechanic's Tool Kit,
Dry cleaning solvent (E17) is flammable
NSN 5180-00-323-4944
and toxic. It can irritate skin and cause
Goggles
burns. Use only in well-ventilated area,
Compressed Air Source
away from heat and open flame. In case
of contact, immediately flush skin or
eyes with water for at least 15 minutes.
Materials:
Dry Cleaning Solvent (E17)
Get medical attention for eyes.
Gloves (E20)
Personnel Required:
68B10 Aircraft Powerplant Repairer
When using compressed air for cleaning,
Equipment Condition:
Off Engine Task
use approved protective equipment for
Oil Filler Assembly and Oil Filler Strainer
eyes and face. Do not use more than
Removed (Task 8-16)
30 psig air pressure. Do not direct air
Oil Filler Assembly and Oil Filler Strainer
toward yourself or another person.
Disassembled (Task 8-17)
Failure to comply could result in in-
jury to eyes or skin. In case of injury,
get medical attention.
1. Clean oil filler assembly (1) as follows:
a. Wear gloves (E20). Immerse filler assembly
(1) in dry cleaning solvent (E17) and agitate.
Use brush on inner surfaces.
b. Wear goggles and blow dry any remaining sol-
vent. Use clean, dry compressed air.
GO TO NEXT PAGE
