TM 55-2840-254-23
7-14
INITIAL SETUP
Materials:
Crocus Cloth (E15)
Applicable Configurations:
All
Personnel Required:
68B10 Aircraft Powerplant Repairer
Tools:
68B30 Aircraft Powerplant Inspector
Powerplant Mechanic's Tool Kit,
NSN 5180-00-323-4944
Equipment Condition:
Technical Inspection Tool Kit,
Off Engine Task
NSN 5180-00-323-5114
GoggIes
Compressed Air Source
NOTE
This repair is allowed provided it does
not cause pins to break or crack.
1. Straighten bent pins (1) of ignition exciter (2).
Using long-nose pliers, gently move pins (1) until
they are straight.
2. Remove corrosion from pins (1) of ignition ex-
titer (2). Polish pins, using in and out motion
over entire length of pin until corrosion is re-
moved. Use crocus cloth (E15).
When using compressed air for cleaning,
use approved protective equipment for
eyes and face. Do not use more than 30
psig air pressure. Do not direct air toward
yourself or another person. Failure to
comply could result in injury to eyes or
skin. In case of injury, get medical
attention.
3. Wear goggles. Remove loosened particles from
pins (1), using clean, dry compressed air.
INSPECT
GO TO NEXT PAGE
