TM 55-2840-254-23
6-52
INITIAL SETUP
Materials:
Crocus Cloth (E15)
Applicable Configurations:
All
Personnel Required:
68B10 Aircraft Powerplant Repairer
Tools:
68B30 Aircraft Powerplant Inspector
Powerplant Mahanic's Tool Kit,
NSN 5180-00-323-4944
Equipment Condition:
Technical Inspection Tool Kit,
Off Engine Task
NSN 5180-00-323-5114
Goggles
Compressed Air Source
NOTE
This repair is allowed provided it does
not cause pins to break or crack.
1. Straighten bent pins (1) of starting fuel sole-
noid valve (2). Using long-nose pliers, gently
move pins (1) until they are straight.
2. Remove corrosion from pins (1) of starting fuel
solenoid valve (2). Polish pins, using in and out
motion over entire length of pin until corrosion
is removal. Use crocus cloth (E15).
When using compressed air for cleaning,
use approved protective equipment for
eyes and face. Do not use more than
30 psig air pressure. Do not direct air
toward yourself or another person.
Failure to comply could result in injury
to eyes or skin. In case of injury, get
medical attention.
3. Wear goggles. Remove loosened particles from
pins (1), using clean, dry compressed air.
INSPECT
FOLLOW-ON MAINTENANCE:
None
END OF TASK
