TM 55-2840-254-23
1-106
WASH COMPRESSOR (WITHOUT WATER WASH KIT P/N 2-200-071-54
1-106
P/N 2-200-071-54 INSTALLED) (Continued)
d. Stop motoring engine. Let stand for
WARNING
20 minutes to loosen deposits.
Cleaning solution (E11) is not toxic,
but fumes may cause irritation. Use
only with adequate ventilation. Avoid
prolonged or repeated breathing of
vapors.
NOTE
In following step b., cleaning solution
(E11) may be used for removal of light
oil and dirt. Dry Cleaning solvent (E17)
may be used for removal of oil, grease,
or dirt. If used, go to step c. Clean, fresh
water may be used for removal of dirt
and salt deposits. If used, go to step e.
b. Mix a solution of cleaning solution
(E11) with water. Mix four quarts of
water to one quart of solution in a
clean utility pail (6).
c. While engine is cold and with ignition
circuit breaker pulled out, have
helper motor engine while spraying
cleaning solution (E11 or E17)
evenly through all sections of the
inlet housing (7). (Ref. TM 55-1520-
240-10 or Task 1-107).
WARNING
When using compressed air for
cleaning, use approved protective
equipment for eyes and face. Do not
use more than 30 PSIG pressure. Do
not direct air pressure toward
yourself or another person. Failure to
comply could result in injury to eyes
or skin. In case of injury, get medical
attention.
GO TO NEXT PAGE
1-456.4
Change 12
