TM 55-2840-254-23
1-98
1-98 SERVICE NO. 4 AND 5 BEARING OIL FILTER (Continued)
c. Find gap measured in shim selection table.
SHIM SELECTION TABLE
Read across table to find thickness of shim(s)
needed.
IF GAP
SHIM THICKNESS
REQUIRED
MEASURES
INCHES
INCHES
None
0.060
None
0.061
0.062
0.003 to 0.005
0.063
0.003 to 0.005
0.064
0.003 to 0.005
0.006 to 0.010
0.065
0.066
0.006 to 0.010
0.006 to 0.010
0.067
0.008 to 0.012
0.068
0.008 to 0.012
0.069
0.008 to 0.012
0.070
0.009 to 0.015
0.071
0.011 to 0.017
0.072
0.011 to 0.017
0.073
0.011 to 0.017
0.074
0.012 to 0.020
0.075
0.014 to 0.022
0.076
0.014 to 0.022
0.077
0.016 to 0.024
0.078
0.016 to 0.024
0.079
0.016 to 0.024
0.080
0.016 to 0.024
0.081
0.019 to 0.029
0.082
0.019 to 0.029
0.083
0.019 to 0.029
0.084
0.022 to 0.034
0.085
0.022 to 0.034
0.086
0.022 to 0.034
0.087
0.022 to 0.034
0.088
0.024 to 0.036
0.089
0.024 to 0.036
0.090
d. Measure thickness of shims (11) and check
against Shim Selection Table. Use outside
micrometer caliper.
GO TO NEXT PAGE
1-392
