TM 55-2835-208-23
2-105 REPLACE ACCESSORY DRIVE ASSEMBLY OIL SEALS (AVIM) (Continued)
2-105
1.
2.
3.
4.
5.
Drill 0.1250 inch diameter hole into casing of
oil seals (1) and (5). Do not drill through seal.
Screw seal puller (T13) (2) into drilled hole.
Operate slide hammer (3) to pull out seals (1)
and (5) from housing (4).
Apply a light coat of assembly
fluid (E31) to lip of seals
(1) and (5).
Using seal driver (T4) (6) in-
stall
seals (1), and drive
until flush with recessed sur-
faces of housing (4).
Using seal driver (T2) (7) In-
stall seals (5) and drive in
seal until flush with recessed
surfaces of housing (4).
INSPECT
FOLLOW-ON MAINTENANCE:
None
Change 5
2-191
