ARMY TM  5-6115-612-34 MARINE  CORPS  TM  6115-34/8 AIR  FORCE TO  35C2-3-471-2 NAVY AG-320130-MME-000 8-5. OVERHAUL  OF  GEARBOX  ASSEMBLY. (cont) c. Cleaning. CAUTION To prevent subsequent problems with components, use caution in cleaning so as not to remove evidence of damage. Inspect both before and after cleaning. (1) Vapor degrease and steam clean all oil tubes and fittings. (2) Vapor degrease and steam clean starter mounting cover. (3) Vapor degrease and steam clean starter spur gear. (4) Vapor degrease and steam clean seal retainer, generator shouldered shaft,   and output spur gear. (5) Vapor degrease and steam clean pinion spur gear and gearbox housing. d. Inspection. (6) Inspect starter spur gear for cracks, wear, broken teeth, and other damage. (7) Check dimensions of starter on spur gear in accordance with table 1-1. (8) Refer to table 8-3. Perform nondestructive test on starter spur gear. (9) Inspect seal retainer for galling, broken ears, and other damage. (10) Refer to table 8-3. Perform nondestructive test on seal retainer. (11) Inspect generator shouldered shaft for nicks, scratches, broken or deformed splines, and  for  excessive wear. (12) Check dimensions on generator shouldered shaft in accordance with table  1-1. (13) Refer to table 8-3. Perform (1) Inspect oil tubes for wear, nondestructive test   on generator chafing, cracks, or other damage. shouldered shaft. (2) Measure openings in ends of oil tubes with wire gage. Opening in tube must be 0.030-0.040 inch (0.076- 0.102 cm). (3) Inspect starter mounting cover for  cracks,    wear, corrosion, or other damage. (4) Refer to table 8-3. Perform nondestructive test on starter mounting cover. (5) Check dimensions of starter mounting cover in accordance with table 1-1. (14) Inspect output spur gear for cracks, wear, broken teeth, and other damage. (15) Refer to table 8-3. Perform nondestructive test on output spur gear. (16) Inspect pinion spur gear for nicks. scratches. broken or deformed –7 , splines,    and for excessive wear. (17) Check dimensions on pinion spur gear in accordance with table 1-1. (18) Refer to table 8-3. Perform nondestructive test on pinion spur gear. 8-52