ARMY
TM 5-6115-612-34
NAVY
AG -320B0-MME-000
7-4.
OIL PUMP. (cont)
c.
Installation. (cont)
(5)
Install performed packing (18) on
housing access cover (17).
(6)
Install housing access cover (17),
washers (16), and bolts (15). Torque bolts to 20-25 inch
pounds (2.3-2.8 Nm).
(7)
Carefully install shouldered quill shaft
(14) in shouldered drive shaft (21) with slotted end out.
Secure shafts together with drive pin (13).
NOTE
Gear is slotted to fit over drive pin.
(8)
Install
pump
spur
gear
(12)
on
shouldered drive shaft (14)
(9)
Install idler shaft (11) in oil pump
housing (23).
(10) Install new preformed packing (10) and
idler spur gear (9) on idler shaft (11).
(11) If removed, install new helical coil
inserts (8).
NOTE
Housing cover (6) and oil pump
housing (23) come as a matched
set.
NOTE
It
may
be
necessary
to
cool
housing cover (7) approximately
10-15 minutes in an alcohol and dry
ice solution to ease installation.
(12) Install housing cover (7) in housing
(23) with capscrews (6). Torque capscrews to 15-18
inch pounds (1.7 -2.0 Nm).
(13) Install new performed packings (4 and
5) * in gearbox.
NOTE
Insure shaft rotates freely by hand
prior to installation.
(14) Carefully place assembled oil pump
assembly (3) in gearbox and secure with washers (2)
and bolts (1). Torque bolts to 27-30 inch pounds (3.1-3.4
Nm).
(15) Install engine housing access cover
and secure with turnlock fasteners.
Change 4 7-9/(7-10 blank)
