ARMY
TM 5-6115-612-34
MARINE CORPS TM 6115-34/8
AIR FORCE
TO 35C2-3-471-2
NAVY
AG-320BO-MME-OOO
5-2. GENERATOR ASSEMBLY MAINTENANCE.
(cont)
f.
Reassembly. (cont)
(26) Secure diodes in rectifier
ring with lockwashers (29, figure 5-5)
and nuts (28).
Torque to 100-125 inch
pounds (11.3-14.1 Nm).
(27) Position rectifier ring on
rectifier mounting flange (40).
Ensure
that matchmarks are alined.
CAUTION
To
prevent
damage, it is
extremely
important
that
each
stator wire is installed in the
same
rectifier ring
slot from
which removed.
(28) Pop plastic grommets and
stator wires into correct keyhole slots
in rectifier
ring (27).
Refer to
figure 5-7 for stator to diode wire
routing.
(29) Check
alinement
of
matchmarks on
rectifier
ring
and
rectifier
mounting
flange.
Secure
rectifier
ring to
flange
with
lockwashers
(26,
figure
5-5)
and
capscrews (25).
Torque to 9-15 inch
pounds (1.0-1.7 Nm).
CAUTION
To
prevent
damage, it is
extremely
important
that each
stator wire be attached to the
same diode from which it was
removed.
(30) Attach each stator wire to
same diode from which it was removed
during
disassembly.
Secure
stator
wires to diodes with capscrews (24) and
nuts (23).
Torque to 17-23 inch pounds
(1.9-2.6 Nm).
(31) Position
mounting
flange
(13) on stator housing (46).
Ensure
that matchmarks are
mounting.
(32) Apply
compound to capscrews
(33) Position
(13) on stator housi
that matchmarks are
alined.
Secure
thread-locking
(12).
mounting
flange
ng (46).
Ensure
alined.
Secure
mounting flange to stator housing with
capscrews (12).
Torque to 84-108 inch
pounds (9.5-12.2 Nm).
(34) Position resistor R1 (50,
figure 5-4) on right side panel (51)
and secure with washers (49), screws
(48), lockwashers (47), and nuts (46).
(35) Position capacitor C1 (44)
on right side panel.
Place cloth tape
(45) and capacitor retaining straps
(43) over capacitor and secure with
washers (42), screws (41), lockwashers
(40), and nuts (39).
(36) Attach wiring to capacitor
with lockwashers (38) and screws (37).
Remove tags.
(37) Apply adhesive to mounting
surfaces of
positive
and
negative
output connectors (34, 35) and install
in left side panel (36).
Secure with
spanner nuts (33).
Torque to 130-150
inch pounds (14.7-17.0 Nm).
(38) Slip GECM connector wiring
through GECM connector mounting hole in
left side panel.
Secure connector (32)
to left side panel with lockwashers
(30),
screws
(31), and nuts (29).
Lockwire as necessary.
5-16
