4-81.
POWER CABLE ASSEMBLY.
b. Installation. (cont)
washers (5) and nuts (4).
24-36 inch pounds (2.7-4 Nm)
(cont)
Torque to
(4) Install loop clamps (12) and
secure with washers (10), screws (9),
and nuts (11).
Torque to 36-40 inch
pounds (4-4.5 Nm).
(5) Install output cable housing
(8) and secure with washers (7) and
screws (6).
(6) Close
and
securely
latch
inlet air housing access door.
(7) Install output/slave housing
access
cover
(3) and secure with
washers (2) and screws (1).
Torque to
24-36 inch pounds (2.7-4 Nm).
(8) Connect battery cable plug
connector to battery.
(9) Install power cable on cable
support.
4-82. COMPONENT
MOUNTING
PANEL.
Maintenance of the component mounting
panel (figure 4-49) is limited to
replacement.
a. Removal.
(1) Remove power cable from cable
support.
WARNING
To prevent injury, ensure that
battery is
disconnected before
performing
maintenance
on
electrical components.
b. Installation.
(2) Disconnect battery cable plug
connector.
ARMY
TM 5-6115-612-12
MARINE CORPS TM 6115-12/7
AIR FORCE
TO 35C2-3-471-1
NAVY
AG-320B0-0MM-000
(3) Unlatch and open inlet air
housing access door.
Secure in open
position.
(4) Loosen turnlock fasteners and
remove engine housing access cover.
(5) Remove air baffle from inlet
air housing (paragraph 4-22).
(6) Carefully tag and disconnect
all
wiring
connected
to components
installed on mounting panel.
(7) Remove screws (l), washers
(2),
and self-locking nuts (3) that
secure mounting panel (4) in inlet air
housing.
Carefully remove panel.
(8) Remove
components
from
mounting
panel .
Component
removal
procedures are presented in paragraphs
4-83 through 4-88.
(1) Refer to
paragraphs
4-83
through 4-88 and install components on
mounting panel (4).
(2) Carefully
place
panel in
position in inlet air housing.
Secure
with bolts (1), washers (2), and
self-locking nuts (3). Torque to 36-40
inch pounds (4-4.5 Nm).
(3) Connect
wiring
to
components.
Remove tags.
(4) Refer to paragraph 4-22 and
install air baffle.
(5) Install engine housing access
cover
and secure
with
turnlock
fasteners.
(6) Close
a n d
securely latch
inlet air housing access door.
4-149
