APPENDIX B COMPONENTS OF END ITEMS LIST

APPENDIX A REFERENCES - TM-5-6115-590-12_199

Section II Integral Components of End Items

TM-5-6115-590-12 Generator Set Engine Driven Tactical Skid Mtd 10 Kw 1 Phase - 2 Wire 1 Phase - 3 Wire 3 Phase - 4 Wire Manual
Page Navigation
181

TM 5-6115-590-12 APPENDIX B COMPONENTS OF END ITEMS LIST Section I. Introduction B-1. Scope This appendix lists integral components of and basic issue items for the power plant to help you inventory items required for safe and efficient B-2. General The Components of End Items List is divided into the following sections: a. Section II. Integral Components of the End Item. These items, when assembled, comprise the power plant and must accompany it whenever it is transferred or turned in. These illustrations will help you inventory these items. b. Section III. Basic Issue Items. These are minimum essential items required to place the power plant in operation, to operate it, and to perform emergency repairs. Although shipped separately packed they must accompany the power plant during operation and whenever it is transferred between accountable officers. The illustrations will assist you with hard-to-identify items. This manual is your authority to requisition replacement BII, based on Table(s) of Organization and Equipment (TOE)/(MTOE) authorization of the end item. B-3. Explanation of Columns a. Illustration. This column is divided as follows: (1) Figure Number. Indicates the figure number of the illustration on which the item is shown (if applicable). (2) Item Number. The number used to identify item called out in the illustration. b. National Stock Number (NSN). Indicates the National stock number assigned to the item and which will be used for requisitioning. c. Part Number (P/N). Indicates the primary number used by the manufacturer, which controls the design and characteristics of the item by means of its engineering drawings, specifications, standards, and inspection requirements to identify an item or range of items. d. Description. Indicates the Federal item name and, if required, a minimum description to identify the item. e. Location. The physical location of each item listed is given in this column. The lists are designed to inventory all items in one area of the major item before moving on to an adjacent area. f. Usable on Code. "USABLE ON" codes are included to help you identify which component items are used on the different models. Identification of the codes used in these lists are: Code Used On None None g. Quantity Required (Qty Reqd). This column lists the quantity of each item required for a complete major item. h. Quantity. This column is left blank for use during inventory. Under the Rcvtd column, list the quantity you actually receive on your major item. The Date columns are for use when you inventory the major item at a later date; such as for shipment to another site. B-1

Privacy Statement
Press Release
Contact