TM 1-2840-252-23-3
8-125
INSPECT OIL LEVEL FLOAT ASSEMBLY (AVIM)
8-125
INITIAL SETUP
Materials:
Applicable Configurations:
None
All
Personnel Required:
Tools:
Aircraft Powerplant Inspector
Technical Inspection Tool Kit,
Equipment Condition:
NSN 5180-00-323-5114
Off Engine Task
Outside Micrometer Caliper Set
1. Inspect float (1). There shall be no cracks.
2. Inspect hole (2) in float (1). Hole diameter shall be 0.240 inch maximum.
3. Inspect shaft (3). There shall be no cracks.
4. Inspect notch (4). There shall be no nicks, burrs, or scratches deeper than 0.020 inch on flat surface (5).
5. Inspect float mounting area (6). Use outside micrometer caliper. Shaft diameter shall be 0.184 inch minimum.
6. Inspect washer (7). Washer (7) shall not be cracked, loose, or missing.
FOLLOW-ON MAINTENANCE:
None
END OF TASK
8-314
