TM 1-2840-252-23-3
8-104
INSTAL L NO. 4 AND 5 BEARING FILTER (Continued)
8-104
CAUTION
Concave side of washer must face fire- shield section. Failure to comply will place
wrong tension on internal oil tube.
CAUTION
Do not tighten reducer in following step.
Tightening of reducer may damage
internal oil tube .
2.
Remove reducer (1). Loosely install shims (4), washer (5), concave side down, and reducer (1).
CAUTION
Adapter must be held firmly when tightening reducer. Failure to comply will cause
damage to internal tube assembly.
3.
Hold adapter (2) with open-end wrench (T24) (6). Torque reducer (1) to 115 inch-pounds and lockwire. Use
lockwire (E33).
GO TO NEXT PAGE
8-264