TM 1-2840-252-23-3
8-35
CLEAN OIL FILTER COVER ASSET[VBLY AND OIL FILTER ELEMENT
8-35
INITIAL SETUP
Equipment Condition:
Applicable Configurations:
Off Engine Task
All
Engine Oil System Drained (Task 1-69)
Oil Filter Cover Assembly and Oil Filter
Tools:
Element Removed (Task 8-34)
Powerplant Mechanic's Tool Kit,
General Safety Instructions:
NSN 5180-00-323-4944
Goggles
WARNING
Dry, Compressed Air Source
Dry cleaning solvent (E19) is flammable and
Materials:
toxic. It can irritate skin and cause burns.
Dry Cleaning Solvent (E19)
Use only in well-ventilated area, away from
Gloves (E24)
heat and open flame. In case of contact,
Lint-Free Cloth (E30)
immediately flush skin or eyes with water for
Personnel Required:
at least 15 minutes. Get medical attention
Aircraft Powerplant Repairer
for eyes.
1. Clean oil filter cover assembly (1) as follows:
a. Wear gloves (E24). Immerse and agitate oil filter cover assembly (1) in dry cleaning solvent (E19). Use brush
on outside surfaces.
b. Wipe outside surfaces dry with clean, dry, lint-free cloth (E30).
WARNING
When using compressed air for cleaning, use approved protective equipment for eyes and face. Do not
use more than 30 psig air pressure. Do not direct air toward yourself or another person. Failure to
comply could result in injury to eyes or skin. In case of injury, get medical attention.
c. Wear goggles. Blow dry internal and external surfaces using clean, dry, compressed air.
FOLLOW-ON MAINTENANCE:
Inspect Oil Filter Cover Assembly and Oil Filter Element (Task 8-36).
END OF TASK
8-85
