TM 1-2840-252-23-3
8-29
CLEAN OIL FILLER ASSEMBLY AND OIL FILLER STRAINER (Continued)
8-29
INITIAL SETUP
General Safety Instructions:
Applicable Configurations:
WARNING
All
Dry cleaning solvent (E19) is flammable and
Tools:
toxic. It can irritate skin and cause burns.
Powerplant Mechanic's Tool Kit,
Use only in well-ventilated area, away from
NSN 5180-00-323-4944
heat and open flame. In case of contact,
Goggles
immediately flush skin or eyes with water for
Dry, Compressed Air Source
at least 15 minutes. Get medical attention
Materials:
for eyes.
Dry Cleaning Solvent (E19)
Gloves (E24)
WARNING
Personnel Required:
When using compressed air for cleaning,
Aircraft Powerplant Repairer
use approved protective equipment for eyes
Equipment Condition:
and face. Do not use more than 30 psig air
Off Engine Task
pressure. Do not direct air toward yourself
Oil Filler Assembly and Oil Filler Strainer Removed
or another person. Failure to comply could
(Task 8-27)
Oil Filler Assembly and Oil Filler Strainer Disas-
result in injury to
sembled (Task 8-28)
eves or skin. In case of injury, get medical
attention.
1. Clean oil filter assembly (1) as follows:
a. Wear gloves (E24). Immerse filler assembly (1) in dry cleaning solvent (E19) and agitate. Use brush on inner
surface.
b. Wear goggles. Blow dry any remaining solvent. Use clean, dry, compressed air.
GO TO NEXT PAGE
8-73
