TM 1-2840-252-23-3
7-29
CLEAN ACCESSORY ELECTRICAL HARNESS ASSEMBLY
7-29
INITIAL SETUP
Equipment Condition:
Applicable Configurations:
Off Engine Task
All
Accessory Electrical Harness Assembly Removed
Tools:
(Task 7-28)
Powerplant Mechanic's Tool Kit,
General Safety Instructions:
NSN 5180-00-323-4944
WARNING
Goggles
Denatured alcohol (E17) is flammable
Dry, Compressed Air Source
and toxic. It can irritate skin and cause burns.
Materials:
Use only in well-ventilated area,
Gloves (E24) burns.
away from heat and open flame. In case
Lint-Free Cloth (E30)
of contact, immediately flush skin or
Denatured Alcohol (E17)
eyes with water for at least 15 minutes.
Personnel Required:
Get medical attention for eyes.
Aircraft Powerplant Repairer
1. Wear gloves (E24).
Clean accessory electrical
harness assembly (1).
Use lint-free cloth (E30)
dampened with denatured alcohol (El 7). Wipe dry
using clean, dry, lint-free cloth (E30).
2. Clean eight electrical connectors (2).
Use
denatured alcohol (El 7) and brush.
WARNING
When using compressed air for clean- ing, use
approved protective equipment for eyes and face.
Do not use more than 30 psig air pressure. Do
not direct air toward yourself or another person.
Failure to comply could result in injury to eyes or
skin. In case of injury, get medical attention.
3. Wear goggles.
Blow dry electrical connector
(2). Use clean, dry, compressed air.
FOLLOW-ON MAINTENANCE:
Inspect Accessory Electrical Harness Assembly
(Task 7-30).
END OF TASK
7-143
