TM 1-2840-252-23-2
SECTION IV
FUEL BOOST PUMP ASSEMBLY-PREPERATION FOR STORAGE OR
SHIPMENT
6-13
INITIAL SETUP
Lubricating Oil (E35)
High Pressure Plugs
Applicable Configurations:
All
Personnel Required
-
Aircraft Powerplant Repairer
Tools.
Powerplant Mechanic's Tool Kit,
Equipment Condition:
NSN 5180-00-323-4944
Off Engine Task
Fuel Boost Pump Assembly Removed (Task 6-8)
Materials:
Gloves (E24)
1. Install high pressure plugs (1) in ports (2 and 3)
on fuel boost pump assembly (4)
WARNING
Lubricating oils cause paralysis if swal-
lowed. Prolonged contact with them
may irritate the skin. Handle only in
well-ventilated areas away from heat
and flame. Drain and store in approved
metal safety containers. Avoid pro-
longed or repeated contact with skin
and do not take internally. Wash con-
tacted area of skin thoroughly after han-
dling. If Irritation of skin results, get
medical attention Get medical attention
for eyes.
2. Wear gloves (E24) Pour lubricating oil (E35)
in port (5) until port (5) is filled.
3. Install high pressure plug (1) in port (5).
4. Rotate fuel boost pump spline (6) counterclock-
wise by hand at least three revolutions.
5. Remove high pressure plug (1) from port (5)
and refill port (5) with lubricating oil (E35)
6. Install high pressure plug (1) in port (5)
FOLLOW-ON MAINTENANCE
Package Fuel Boost Pump Assembly (Task 6-14)
END OF TASK
