TM 1-2840-252-23-2
2-40
CLEAN OUTPUT SHAFT SEAL AND HOUSI ASSEMBLY
NG
2-40
INITIAL SETUP
Equipment Condition:
Off Engine Task
Output Shaft Seal and Housing Assembly Re-
Applicable Configurations:
All
moved (Task 2-39)
Tools:
General Safety Instructions
Powerplant Mechanic's Tool Kit,
WARNING
NSN 5180-00-323-4944
Goggles
Dry cleaning solvent (E19) is flammable
Dry, Compressed Air Source
and toxic It can irritate skin and cause
Material:
burns. Use only in well-ventilated area,
Dry Cleaning Solvent (E19)
away from heat and open flame. In case
Gloves (E24)
of contact, immediately flush skin or
Lint-Free Cloth (30)
eyes with water for at least 5 minutes
1
Personnel Required:
Get medical attention for eyes
Aircraft Powerplant Repairer
1. Wear gloves (E24) Immerse output shaft seal
housing assembly (1) in dry cleaning solvent (E19)
and agitate. Use brush on inside surfaces (2)
2. Wipe dry. Use clean, dry, lint-free cloth (E30)
WARNING
When using compressed air for cleaning,
use approved protective equipment for
eyes and face. Do not use more than 30
psig air pressure. Do not direct air
toward yourself or another person.
Failure to comply could result in injury
to eyes or skin. In case of injury, get
medical attention.
3. Wear goggles Blow dry inside surfaces (2) using
clean, dry, compressed air
FOLLOW-ON MAINTENANCE
Inspect Output Shaft Seal and Housing Assembly
END OF TASK
2-328
