CLEAN AND INSPECT START BYPASS VALVE

INSTALL EXTERNAL LINES AND FITTINGS (Continued)

TM-55-2835-208-23 Transportability Guidance Small Emplacement Excavator (SEE) High Mobility Entrencher (HME) High Mobility Material Handler (HMMH) Manual
Page Navigation
63

TM 55-2835-208-23 2-9 CLEAN AND INSPECT START BYPASS VALVE 2-9 INITIAL SETUP Materials: Applicable Configurations: Dry-Cleaning Solvent (E20) Lint-Free Cloth (E13) All Personnel Required: Tools : 68B Aircraft Powerplant Repairer Engine Repairman’s Tool Kit 68B Powerplant Inspector NSN 5180-00-323-4944 Rubber Gloves Equipment Condition: NSN 8415-00-266-8677 Eye Protection APU in Assembly Fixture (Task 1-22) 1. Inspect start bypass valve (1) for chafing, security of in- stallation, gouges and cracks. If damage exists replace valve (Task 2-10). Dry-cleaning solvent (E20) is flammable and toxic. It can irritate skin and cause burns. Use only in well-ventilated area, away from heat and open flame. Wear gloves and eye pro- tection. In case of contact, immediately flush skin or eyes with water for at least 15 minutes. Get medical attention for eyes. 2. Wipe exterior of start bypass valve (1) with a clean cloth (E13) moistened with dry- cleaning solvent (E20). 3. Allow to air dry. FOLLOW-ON MAINTENANCE: None END OF TASK 2-22

Privacy Statement
Press Release
Contact