TM 55-2840-254-23
ILLUSTRATED LIST OF MANUFACTURED ITEMS (Continued)
Nomenclature
Reference Task No.
Material Required
Third Turbine Rotor
4-37
Hardwood Stock
Support Block (AVIM)
Fabrication Instructions:
Fabricate third turbine rotor support block out of hardwood stock as follows:
1. Saw wood in accordance with sketch shown below.
2. Remove all rough edges with fine grain sandpaper.
NOTE: Size of required block will vary with distance from floor to turbine shaft. All dimensions are in
inches. Dimensions given below are examples only.
Sketch or Diagram:
Change 1
