TM 55284025423
910 INSTALL OUTPUT SHAFT (Continued)
910
10. Push on output shaft (1) and check depth
from flange (16) to edge of bearing (17).
Depth shall not be less than 0.510 inches
or more than 0.540 inches.
11. Disassemble and repeat steps 4, thru 10. if di-
mensions are not within limits.
NOTE
After replacement of the output shaft a Tur-
bine Engine Analysis Check and Baseline
Hit Check are required (Ref. TM
55152024023).
INSPECT
FOLLOWON MAINTENANCE:
Install Output Shaft Seal and Housing Assembly
(Task 252)
Service Engine Oil System (Task 174)
GO TO NEXT PAGE
938 Change 7
