TM 55-2840-254-23
1-107
1-107 TEST ENGINE (AVIM) (Continued)
m. Check engine for leaks, and listen for any unusual noises during engine coastdown.
NOTE
No fuel should come from engine combustion chamber drain
vaIves.
n. Place test log on control room panel bench.
o. Add oil as necessary to refill engine oil reservoir. Record amount added.
NOTE
Engine oil level indicator should be reading slightly less than full.
p. Empty all seal drain bottles.
q. Position FUEL CONT and FUEL SOL switches to OFF,
3. ENGINE STARTING PROCEDURE
Observe starter limitations as recommended by manufacturer. Failure
to comply may cause damage to starter.
a. Position MASTER SWITCH and 400 CYCLE switches to ON.
b. Allow fuel to flow to fuel control by placing fuel solenoid switch to ON.
c. Preset N1 master hydronic control to OFF.
d. Preset power turbine master hydronic control to fully retarded (minimum) position,
GO TO NEXT PAGE
1-460