ARMY TM 5-6675-309-14
MARINE CORPS TM 08840A-14/1
c. Column 3: Maintenance Functions. Column 3
and support equipment required to perform the desig-
lists functions to be performed on the items listed in
nated function.
Column 2.
f. Column 6: Remarks. Column 6 contains an al-
phabetic code referring to Section IV, Remarks, which
d. Column 4: Maintenance Category. Column 4
is pertinent to the item opposite the particular code.
specifies, by listing of a "work-time" figure in the
appropriate column(s), the lowest level of maintenance
D-4. Tools and Test Equipment Requirements, Section
authorized to perform the function listed in Column 3.
III.
This figure represents the active time required to per-
form that maintenance function at the indicated cate-
a. Column 1: Reference Code. The numbers in this
gory of maintenance. If the number or complexity of
column coincide with the numbers used in the tools and
the tasks within the listed maintenance function vary at
equipment column of the Maintenance Allocation
different maintenance categories, appropriate "work-
Chart.
time" figures will be shown for each category. The
b. Column 2: Maintenance Category. The codes in
number of man-hours specified by the work-time figure
this column indicate the maintenance categories allo-
represents the average time required to restore an item
cated.
(assembly subassembly, component, module, end item,
c. Column 3: Nomenclature. This column lists
or system) to a serviceable condition under typical field
tools, tests, and maintenance equipment required to
operation conditions. Subcolumns of the maintenance
perform the maintenance functions.
category are as follows:
d. Column 4: National/NATO Stock Number. This
H
General Support
column lists the National/ NATO Stock Number of the
D
Depot
specific tool or test equipment.
e. Column 5: Tools and Equipment. Column 5
e. Column 5: Tool Number. This column lists man-
specifies by code, defined in Section III, those common
ufacturing part number and Federal Supply Code for
tool sets not individual tools) and special tools, test,
Manufacturers (FSCM).
D-2
