ARMY
TM 5-6115-612-12
MARINE CORPS TM 6115-12/7
AIR FORCE
TO 35C2-3-471-1
NAVY
AG-320B0-0MM-000
3-9. FUEL SYSTEM.
Internal
Fuel
System
Com-
ponents.
(See figure 3-7.)
(1) Remove power cable from cable
support assembly.
(2) Unlatch and open fuel housing
access door.
Secure in open position.
(3) Inspect for loose fasteners
and loose electrical connections on
fuel transfer pump, high pressure fuel
pump, and solenoid valve.
(4) Open
control
panel
access
door and place MASTER SWITCH in RUN
position.
This
will
actuate
fuel
transfer pump
and
pressurize
fuel
system up to high pressure fuel pump
with 7 psi (48.26 kPa).
(5) Inspect
for leaks at fuel
line connections at ports of primary
filter.
Inspect for leaks at gasket
where bowl fits into housing.
(6) Inspect
for leaks at fuel
line connections at ports of secondary
fuel filter.
Inspect
for leaks at
gasket where bowl fits into housing.
(7) Inspect
for leaks at fuel
line connections on fuel transfer pump,
high pressure fuel pump, and solenoid
valve.
(8) Ensure that fuel lines in
fuel housing are securely fastened.
(9) Inspect fuel
tank to fuel housing
loose fasteners.
(10) Place MASTER
position.
(11) Close
and
line from fuel
for leaks and
SWITCH in OFF
securely
latch
control panel access door.
(12) Close and
securely
latch
fuel housing access door.
(13) Stow power cable on cable
support assembly.
b.
Fuel Tank.
(1) Inspect fuel tank for leaks.
(2) Ensure that fuel tank is
securely attached to generator set.
(3) Check filler cap and gasket
for damage.
(4) Ensure
that fuel gage is
securely mounted.
3-10.
LUBRICATION
ASSEMBLY.
See
figure 3-1 and inspect oil level gage.
a.
Ensure that MASTER SWITCH is OFF.
b. Unscrew and remove oil filler
cap.
Inspect gasket and threads for
damage.
d.
Inspect
oil
level
gage for
damage.
Install oil filler cap.
Turn
until hand tight.
3-15
