ARMY
TM 5-6115-612-12
MARINE CORPS TM 6115-12/7
AIR FORCE
TO 35C2-3-471-1
NAVY
AG-320B0-0MM-000
4 - 9 5 .
LUNETTE EYE. (cont)
b.
Installation. (cont)
(3) Deleted.
4 - 9 6 .
SWIVEL CASTER WHEEL AND TIRE.
Maintenance of swivel caster wheel and
tire consists of service, replacement,
and repair.
a.
Service.
(1) Inflate tire to 35-40 psi
(241.3-275.8 kPa).
(2) Lubricate in accordance with
lubrication order (figure 3-2).
b. Removal.
WARNING
To prevent injury, ensure that
handbrake is set and both wheels
are chocked to prevent accidental
movement of generator set during
maintenance.
(1) Set handbrake and chock both
wheels.
(2) Loosen nut (1, figure 4-61).
WARNING
To prevent injury, do not attempt
to lift front of generator set
with less than two persons.
(3) Raise generator set and block
front corners.
(4) Remove nut (1) and bolt (2)
to remove wheel and tire assembly from
fork.
4-172
Change 1
(5) Deflate tire (3).
(6) Remove inner tube (4) from
tire.
(7) Remove tire from wheel rim.
(8) Remove nuts (5), lockwashers
(6), and bolts (7).
(9) Remove tapered nuts (8) and
knurled bolts (9).
Separate
female wheel disk (10) and
disk (11) from flanged tube
(10) Remove
bearing
(12) and roller bearings
flanged tube (15).
(11) Remove grease fi
from flanged tube (15).
c.
Repair.
Use standard
and remove
male wheel
(15).
retainers
(13) from
tting (14)
procedures
to plug tire punctures and to patch
damaged inner tube.
Replace damaged
rim components.
d.
Installation.
(1) Install grease fitting (14)
in flanged tube (15).
(2) Place roller bearings (13) in
flanged
tube (15) and secure with
bearing retainers (12).
(3) Aline female wheel disk (10)
and male wheel disk (11) with mounting
holes in flange of flanged tube (15).
Secure
with knurled bolts (9) and
tapered nuts (8).
(4) Install bolts (7) and secure
with lockwashers (6) and nuts (5).
(5) Install tire (3) on wheel rim
(5).
