ARMY
TM 5-6115-612-12
MARINE CORPS TM 6115-12/7
AIR FORCE
TO 35C2-3-471-1
NAVY
AG-320B0-0MM-000
4-79. HIRING HARNESSES. (cont)
Hiring
Harness W2
Removal.
(Cont)
(12) Pull wiring harness W2 out
of control fender and into inlet air
housing.
(13) Tag and
disconnect wiring
harness W2 connections from terminal
board
T B 1
a n d
other
electrical
components mounted in inlet air housing.
(14) Remove wiring harness W2
from inlet air housing.
d. Wirinq
Harness W2
Repair.
Remove connectors and replace damaged
wiring as necessary.
e.
Wirinq Harness W2 Installation.
(1) Pass
wiring
harness W2
through inlet air housing into control
fender.
(2) Remove tags and connect wir-
ing harness W2 connections to terminal
board
TB1
and
other
electrical
components mounted in inlet air housing.
(3) Install air baffle (paragraph
4-22).
(4) Close
and
securely
latch
inlet air housing access door.
(5) Stow power cable on cable
support.
(6) Remove tags and connect wir-
ing harness W2 to EECM connectors J4
and J6.
(7) Install EECM access cover and
secure with turnlock fasteners.
(8) Open control panel.
(9) On back of control panel,
connect wiring harness W2 to control
panel components.
(10) Remove tags and connect wir-
ing harness W2 to GECM connectors J2
and J3.
(11) Close
control
panel
a n d
secure with turnlock fasteners.
(12) Close control panel access
door.
(13) Connect battery cable plug
connector to battery.
f. Wiring Harness W3 Removal,
WARNING
To prevent injury, ensure that
battery is
disconnected before
performing
maintenance
on
electrical components.
(1) Disconnect battery cable plug
connector from battery.
(2) Remove power cable from cable
support.
(3) Unlatch and open fuel housing
access door.
Secure in open position.
(4) Tag and disconnect electrical
connectors from transfer pump, solenoid
valve, and high pressure pump.
(5) Remove nuts,
washers,
and
screws to free wiring harness from loop
clamps in fuel housing.
(See figure
4-47.)
(6) Loosen turnlock fasteners and
remove engine housing access cover.
4-143
