A R M  Y TM MARINE    CORPS    TM AIR FORCE TO 5-6115-612-12 6115-12/7 35C2-3-471-1 N   A   V   Y AG-320B0-0MM-000 4-64.    ENGINE ELECTRONIC CONTROL MODULE.    ( c o n t) b. Insta llation. (1)   Ensure   that rubber shock mounts  (1)  and  ground  strap  (8)  are  in p l a c e . (2)  Remove tags electrical   connectors   to   EECM and     connect (3) Place EECM     on resilient mounts    (7). (4) Install washers (3) and nuts ( 2 ) . Torque    to    74-82    inch    pounds (8.4-9.3). (5) Install EECM access cover (1) and secure with turnlock fasteners. (6) Close and secure control panel    access    cover. (7)  Connect  battery  cable  plug connector   to   battery. (2) Loosen turnlock fasteners and remove engine housing access cover. (3) Disconnect electrical con- nector from monopole speed sensor. (4)   Set   multimeter   on   R1   and measure resistance across sensor termi- nals. If no continuity is indicated, monopole  speed  sensor  is  faulty  and should be replaced (paragraph 4-65b). (5)  If  continuity  in  excess  of 1000 ohms is indicated, monopole speed sensor is good. (6) Connect electrical connector to monopole speed sensor. (7)  Install engine housing access cover and   secure with turnlock fasteners. (8)  Connect  battery  cable  plug connector to battery. b. Removal. 4-65.    MONOPOLE    SPEED    SENSOR. Main- tenance   of   the   monopole   speed   sensor consists of testing and replacement. WARNING a. Test W A R N I N G To prevent battery  is performing electrical  components. (1) Disconnect battery connector   from   battery. injury, ensure  that disconnected  before maintenance on cable plug To  prevent  injury,  ensure  that battery is disconnected  before performing maintenance on electrical  components. (1) Disconnect battery cable plug connector  from  battery. (2) Loosen turnlock fasteners and remove engine housing access cover. (3) Disconnect electrical connector   (1, figure 4-40) from monopole  speed  sensor  (10) 4-124