ARMY TM  5-6115-612-12 MARINE  CORPS  TM  6115-12/7 AIR  FORCE TO 35C2-3-471-1 NAVY AG-320B0-0MM-000 4-56. FOREIGN OBJECT DEFLECTION SHIELD. (cont) b. Installation.   (cont) (4) Install lockwire as required. (5) Install engine housing access cover and secure with turnlock fasteners. (6)  Connect  battery  cable  plug connector  to  battery. 4-57. RIM CLENCHING  CLAMP. Main- tenance of the rim clenching (V-band) clamp (1, figure 4-36) is limited to inspection. a. Loosen  turnlock  fasteners  and remove  engine  housing  access  cover. b.  Check  rim  clenching  clamp  for tightness,  cracks,  and  other  damage. Check   for   loose,   missing,   or broken  lockwire. d. If clamp is damaged in any way, refer  to  direct  support  for  maintenance. e. Install engine  housing  access cover and secure with turnlock fasteners. 4-58. COMBUSTOR HOUSING. Main- tenance of the combustor housing (2, figure 4-36) a. remove b. is limited to inspection. Loosen turnlock fasteners and engine  housing  access  cover. Inspect for loose alinement bolts (3). Tighten as required. Bolts should be torqued to 30-40 inch pounds (3.4-4.5 Nm). c.   Inspect for   cracks   and   other damage to  housing. If   repair   is required, notify direct support maintenance. d. Install engine  housing  access cover and secure with turnlock fasteners. 4-59. COMPRESSOR INLET HOUSING. Maintenance  of  the  compressor  inlet housing (4, figure 4-36) is limited to inspection. a. Loosen  turnlock  fasteners  and remove  engine  housing  access  cover. b. Remove  foreign  object  deflection shield  (paragraph  4-56). c. Inspect for foreign object damage, cracks, and broken or missing lockwire. d. Ensure monopole speed sensor is securely mounted. Bolt should   be torqued  to  70-80  inch  pounds  (7.9-9 Nm). Ensure that lockwire is secure. e.  If  compressor inlet  housing  is damaged in any  way,  refer  to  depot level for maintenance. f. Install foreign object deflection  shield  (paragraph  4-56). g. Install engine  housing  access cover and secure with turnlock fasteners. 4-60. GEARBOX ASSEMBLY. Main- tenance  of  the  gearbox  assembly  (5, figure  4-36)  is  limited  to  inspection. 4-115