TM 1-2840-252-23-3
G-63
ENGINE OUT INDICATOR (EOI) DOES NOT ILLUMINATE DURING NORMAL SHUTDOWN EXPANDED
INSTRUCTIONS.
Refer to numbered steps in figure 149.
Step 3.
Check harness connector PL1 (figure201) at each DECU for tight connections.
Step 4.
Disconnector connector PL1 to check pins and sockets.
Step 5.
With PL1 and PL3 disconnected, turn on power to caution panel. Short harness PL1 connector socket
DD (figure 202) to airframe ground. EOI should illuminate when DD is grounded.
Step 6.
Before tightening harness connector PL1, be sure that keyway in harness connector is aligned with
keyway in component connector.
Step 9.
Refer to manufacturer's procedure for diagnosing and replacing of EOI.
Step 11.
Refer to manufacturer's procedure for diagnosing and replacing harness.
Step 14
Refer to manufacturer's procedure for diagnosing and replacing harness or caution panel.
G-146
