TM 1-2840-252-23-3
8-118
REPAIR OIL LEVEL INDICATOR
8-118
INITIAL SETUP
Materials:
Applicable Configurations:
Black Baking Enamel (E9)
All
Crocus Cloth (E16)
Solder (E54)
Tools:
Personnel Required:
Powerplant Mechanic's Tool Kit,
NSN 5180-00-323-4944
Aircraft Powerplant Repairer
Technical Inspection Tool Kit,
Aircraft Electrician
NSN 5180-00-323-5114
Aircraft Powerplant Inspector
Soldering Iron, 15/32-Pound
Equipment Condition:
Stainless Steel Wire Brush
Off Engine Tank
1. Repair loose electrical connector (1) as follows:
a. Remove all surface contamination near joint (2). Use stainless steel wire brush.
b. Solder joint (2). Use solder (E54) and soldering iron.
2. Repair electrical connector pin (3) as follows:
NOTE
This repair is allowed provided it does not cause pin to break or crack.
a. Straighten bent pin (3). Use long nose pliers to gently move pin (3) until it is straight.
b. Remove corrosion from pin (3). Polish pin (3), using in and out motion over entire length of pin until corrosion is
removed. Use crocus cloth (El 6).
3. Repair damaged paint on outside of housing (4) and bracket (5). Use black baking enamel (E9).
INSPECT
FOLLOW-ON MAINTENANCE:
None
END OF TASK
8-292
