TM 1-2840-252-23-3
8-94
CLEAN NO. 2 BEARING PRESSURE OIL CONNECTOR
8-94
INITIAL SETUP
Equipment Condition:
Applicable Configurations:
Off Engine Task
All
No. 2 Bearing Pressure Oil Connector Removed
Tools:
(Task 8-93)
Powerplant Mechanic's Tool Kit,
General Safety Instructions:
NSN 5180-00-323-4944
Dry, Compressed Air Source
WARNING
Goggles
Dry cleaning solvent (E19) is flammable and toxic. It
Materials:
can irritate skin and cause burns Use only in well-
.
Dry Cleaning Solvent (El9)
ventilated area, away from heat and open flame In
.
Gloves (E24)
case of contact, immediately flush skin or eyes with
Personnel Required:
water for at least 15 minutes. Get medical attention for
Aircraft Powerplant Repairer
eyes.
1. Wear gloves (E24). Clean No. 2 bearing pressure oil connector (1) , using brush and dry cleaning solvent (E19).
WARNING
When using compressed air for cleaning, use approved protective equipment for
eyes and face. Do not use more than 30 psig air pressure. Do not direct air
toward yourself or another person. Failure to comply could result in injury to
eyes or skin. In case of injury, get medical attention.
2. Wear goggles. Blow dry No. 2 bearing pressure oil connector (1) , using clean, dry, compressed air.
FOLLOW-ON MAINTENANCE:
Inspect No. 2 Bearing Pressure Oil Connector (Task 8-95).
END OF TASK
8-245
