TM 1-2840-252-23-2
5-29
INSTALL OVERSPEED DRIVE AND OUTLET COVER ASSEMBLY (Continued)
5-29
NOTE
If either accessory gearbox assembly or overspeed
drive gear assembly is a replacement, check
backlash on overspeed drive gear (Ref Task 5-30).
1. Install packing (1) on overspeed drive and outlet cover
assembly (2)
WARNING
Lubricating oils cause paralysis If swallowed.
Prolonged contact with them may irritate the
skin. Handle only in well-ventilated areas away
from heat and flame.
Drain and store in
approved metal safety containers Avoid
prolonged or repeated contact with skin and do
not take internally. Wash contacted area of skin
thoroughly after handling. If irritation of skin
results, get medical attention.
Get medical
attention for eyes.
It may be necessary to remove inlet housing
cover assembly (Ref. Task 2-44) to allow visual
Inspection of garter seal while Installing
overspeed drive gearshaft. Failure to properly
install gearshaft could result In damage to garter
seal.
NOTE
Use care in guiding gearshaft through output shaft
support housing garter seal
2. Coat end of gearshaft (3) with shortening compound
(E51), or lubricating oil (E36) or (E37)
3. Align holes (4) in cover (2) with pins (5) and Install
cover assembly (2, four washers (6), and bolts (7)
)
4. Bend tabs of washers (6)
5. Lockwire plug (8) Use lockwire (E33)
INSPECT
5-88
