TM 1-2840-252-23-2
3-8
INSTALL COMBUSTION SECTION AND POWER TURBINE (AVIM) (Continued)
3-8
14. Remove hoist hook (16) and power turbine fixture
(T54) (15).
NOTE
If replacement combustion section and power
turbine is being installed do all steps.
If same combustion section and power turbine that
was removed is being installed, omit step 15.
15. Inspect output shaft end play s follows.
a
NOTE
Due to possible carbon ridge buildup on output
shaft from output shaft seal, movement will be
difficult For this reason, compete removal of output
shaft seal and housing assembly will be required to
obtain proper output shaft end play.
Remove output shaft seal
and
housing
a.
Install output shaft seal
and
housing
b.
16. Install jumper cable assembly (28), key washer
(29), and bolt (30).
GO TO NEXT PAGE
3-107
