TM 1-2840-252-23-2
2-51 REPAIR AIR INLET HOUSING ASSEMBLY
2-51
INITIAL SETUP
General Safety Instructions
:
WARNING
Applicable Configurations.
All
Tools.
The air inlet housing is made from a
Technical Inspections Tool Kit,
magnesium/nickel alloy containing r-
a
NSN 5180-00-323-5114
dioactive thorium; particles of this ma-
Stainless Steel Wire Brush
terial, resulting from blending or polish-
Materials:
mg are hazardous to your health If in-
Clear Synthetic Sealant (El 3)
gested or otherwise Introduced Into
Gray Enamel (E26)
your body. Do not eat, drink, or smoke
Personnel Required.
in any area where these particles might
Aircraft Powerplant Repairer
be present Wash your hands thoroughly
Aircraft Powerplant Inspector
after working with this material If exp-
o
References,
sure or injury occurs, no matter how
Task 1-110
slight, get medical attention
WARNING
The air Inlet housing is made from a
magnesium/nickel alloy containing ra-
dioactive thorium; particles of this ma-
terial, resulting from blending or polish-
ing are hazardous to your health if in-
gested or otherwise introduced into
your body. Do not eat, drink, or smoke
in any area where these particles might
be present. Wash your hands thoroughly
after working with this material. If expo-
sure or Injury occurs, no matter how
slight, get medical attention.
1. Remove corrosionusing stainless steel wire
brush
2. Repair damaged painton air inlet housing as-
sembly (1) as follows
a. Touch up spray painted surfaces, using gray
enamel (E26) (Ref Task 1-110)
b. Touch up clear synthetesine painted surfaces,
using clear synthetic sealant (El 3) (Ref Task
1-110)
INSPECT
FOLLOW-ON MAINTENANCE
None
END OF TASK
2-357/(2-358 blank)
