8-83 INSTALL NO. 4 AND 5 BEARING FILTER (Continued)
Concave side of washer must face fire-
shield section. Failure to comply will
place wrong tension on internal oil tube.
Do not tighten reducer in following
step. Tightening of reducer may dam-
age internal oil tube.
2. Remove reducer (1). Loosely install shims (4),
washer (5), concave side down, and reducer (1).
Adapter must be held firmly when
tightening reducer. Failure to com-
ply will cause damage to internal
3. Hold adapter (2) with open-end wrench (T53)
(6). Torque reducer (1) to 115 inch-pounds.
GO TO NEXT PAGE