TM 55-2840-254-23
7-3
7-3 INSPECT IGNITION COIL AND
CABLE ASSEMBLY
INITIAL SETUP
Materials:
None
Applicable Configurations:
All
Personnel Required:
Tools:
Equipment Condition:
Off Engine Task
NSN 5180-00-323-4844
1. Inspect ignition coil and cable assembly
(1).
a. There shall be no burned insulation (2).
b. Check connectors (3) attached to sheathing.
There shall be no loose connectors (3).
c. Frayed or worn outer steel braid is acceptable
up to 3/4 of the cable circumference; 1/4 of
the cable circumference shall remain intact
frayed or broken wires (4) on sheathing (Ref.
damage is exceeded.
d. The outer steel braid shall not be frayed or
worn over more than 3/4 of the cable
ground shall be over at least 1/4 of the braid.
e. There shall be no cracked or broken
GO TO NEXT PAGE
Change 2