6-32 INSPECT MAIN FUEL FILTER AND BRACKET (Continued)
If bracket has ten bolt holes do steps 4. and
5. and omit step 5.1. and 5.2. If bracket has
eight bolt holes omit steps 4. and 5. and do
steps 5.1. and 5.2.
4. Inspect bracket (5).
a. There shall be no corrosion or pitting.
b. There shall be no bends or distortion in area
around ten bolt holes (6).
5. Inspect bracket (5). There shall be no cracks
beyond the following limits:
a. There shall be no more than one
edge-to-bolt hole crack (7) per each bolt
b. At bolt holes with edge-to-bolt hole crack
(7), there shall be no more than one
additional crack (8). Crack (8) shall be no
more than 1 /16 inch long.
c. There shall be no converging cracks (9)
that might cause material to fall out.
GO TO NEXT PAGE