7-7 REPLACE STUD (AVIM) (CONT)
4. Insert stud (1) slowly with stud in-
staller to allow air to escape. In-
stall until top serrated flange is
0.010 to 0.020 inch below surface of
Location of flange is impor-
tant so that lock ring drive
tool will not make contact.
Any impact or pressure may
cause damage to threads on
5. Install lock ring (2) with lock ring
drive tool to a depth of 0.005 to
0.010 inch below surface of gearbox
Remove excess epoxy primer (D30)
with machinery towel (D20) and dry
cleaning solvent (D35).
7. Air dry for 72 hours at 62 to 92°F
(17 to 33°C) .
FOLLOW-ON MAINTENANCE: None.