5-1 REMOVE APU WIRING HARNESS ASSEMBLY (CONT)
Disconnect electrical connector P8
(26) from low oil pressure switch.
Disconnect electrical connector P3
(27) from fuel control wiring har-
Disconnect electrical connector P5
(28) from oil temperature bulb.
Remove bolt (29) and clamp (30).
Remove bolt (31) and clamp (32).
To allow APU wiring harness assem-
bly to be pulled through front
panel assembly, remove top bolt and
loosen bottom bolt securing inboard
half of firewall sleeve.
Remove APU wiring harness assembly
Clean APU wiring harness assembly
using process 7, Chapter 8.
FOLLOW-ON MAINTENANCE: None.