REMOVE SECOND TURBINE NOZZLE, SPACER, CASE, AND BUMPER
If second turbine spacer came off with second
turbine disc assembly, omit steps 2 thru 6. If
second turbine spacer did not come off with second
turbine disc assembly, do all steps.
2. Draw matchmark (6) on turbine spacer (7) in line with
matchmark (8) on inside of shaft (9). Use marking
3. Assemble details of GP spacer puller (T48) as
a. Turn T-handle (10) clockwise all the way.
Be sure ball is in base of adapter before
installing onto shaft. Ball could easily all out.
This would cause damage to puller.
b. Install ball (11), detail of GP spacer puller
assembly kit (T48) in base of adapter LTCT7923-
04 (12), detail of GP spacer puller assembly kit
c. Install adapter (12) on shaft (13). Install spring pin
(14) into hole (15).
GO TO NEXT PAGE