REMOVE NO. 4 AND 5 BEARING PAKAGE SEALS (AVIM) (Continued)
Remove handle (13), torque multiplier (T50) (9),
drive bar (10), and torque fixture (T19), consisting
of wrench (5), and holding fixture (6).
Remove nut (7) and locking cup (4).
Matchmark shaft groove (14) and fourth stage
turbine rotor (15) Use marking pencil (E38).
Lubricating oils cause paralysis if swallowed. Prolonged contact with them may
irritate the skin Handle only in well-ventilated areas away from heat and flame
Drain and store in approved metal safety containers. Avoid prolonged or repeated
contact with skin and do not take Internally. Wash contacted area of skin
thoroughly after handling. If irritation of skin results, get medical attention Get
medical attention for eyes.
Soak shaft (16) around rotor (15) with penetrating oil
GO TO NEXT PAGE