TM 1-2840-252-23-2
2-55
REPAIR T1 TEMPERATURE SENSOR (Continued)
2-55
INITIAL SETUP
Materials
Crocus Cloth (E16)
Applicable Configurations:
Personnel Required:
All
Aircraft Powerplant Repairer
Tools:
Equipment Condition
Dry, Compressed Air
Off Engine Task
Technical Inspection Tool Kit,
NOTE
This repair is allowed, provided it does not cause
pins to break or crack.
Straighten bent pins (1)of T1 temperature sensor
1.
(2) Use long-nose pliers to gently move pins (1) until
they are straight.
Remove corrosion from pins (1of T1 temperature
)
2.
sensor (2) Polish pin, using in and out motion over
entire length of pin until corrosion is removed Use
crocus cloth (E16).
WARNING
When using compressed air for cleaning, use
approved protective equipment for eyes and face
Do not use more than30 psig air pressure Do not
direct air toward yourself or another person
Failure to comply could result in injury to eyes or
skin. In case of injury, get medical attention.
3
Wear goggles Remove loosened particles, using
clean, dry, compressed air
INSPECT
FOLLOW-ON MAINTENANCE
None
END OF TASK
2-363