8 April 1988
(Supersedes LO 5-6115-612-12, 24 October 1986)
Approved for public release. Distribution is unlimited.
AVIATION GENERATOR SET, GAS TURBINE ENGINE DRIVEN
INTEGRAL TRAILER MOUNTED, 10KW, 28 VOLTS DC
Clean fittings before lubricating. Clean parts with dry clean-
Intervals (on-condition or hard time) and the related taskhour
ing solvent (SD) type II or equivalent. Dry before lubricating.
times are based on normal operation. The taskhour time
specified is the time you need to do all the services prescrib-
The lowest level of maintenance authorized to lubricate a
ad for a particular interval. On-condition (OC) oil sample inter-
point is indicated by one of the following symbols as ap-
vals shall be applied unless changed by the Army Oil Analysis
propriate Operator/crew (C); and Unit Maintenance (O).
Program (AOAP) laboratory. Change the hard time interval if
your lubricants are contaminated or if you are operating equip
You can help improve this manual. If you find any mistakes
ment under adverse operating conditions, including longer-
or if you know of a way to improve the procedures, please let
than-usual operating hours. The hard time interval may be ex-
us know. Mail your letter or DA Form 2028 direct to Com-
tended during periods of low activity, If extended, adequate
mander, U.S. Army Troop Support Command, ATTN: AMSTR-
preservation precautions must be taken. Hard time intervals
MCTS, 4300 Goodfellow Boulevard, St. Louis, MO 63120-1798.
will be applied in the event AOAP laboratory support is not
A reply will be furnished to you.
CARD 1 OF 2